Mazda 3 Remote Key Programming Guide (2003–2013)

Posted on:

πŸ”‘ Manual Remote Programming Procedures – Mazda 3 BK & BL

This guide explains how to manually program remote locking functions for Mazda 3 models that support DIY programming.

⚠️ Important:
These procedures program remote lock/unlock functions only.
They do NOT program the immobiliser transponder chip.
If the vehicle will not start after programming, diagnostic immobiliser programming is required.


Mazda 3 BK – Series 1

2003–2006 πŸ” Manual Remote Programming


Mazda 3 BK – Series 2

2006–2009 πŸ” Manual Remote Programming


Mazda 3 BL

2009–2013 πŸ” Manual Remote Programming

βœ… All Mazda 3 BK (Series 1 & 2) and BL models use the SAME procedure below.


πŸ” Mazda 3 Manual Remote Programming Procedure

  1. REMOVE the key from the ignition.
  2. CLOSE all doors and the boot/trunk.
  3. OPEN the driver’s door.
  4. INSERT the key into the ignition, then switch ON β†’ LOCK 3 times.
  5. Leave the key in the ignition.
  6. CLOSE and OPEN the driver’s door 3 times, then leave the door OPEN.
  7. πŸ”’ The door locks should LOCK then UNLOCK to confirm programming mode.
  8. PRESS the UNLOCK button twice on the first remote.
  9. πŸ”’ The door locks will LOCK β†’ UNLOCK to confirm programming.
  10. Repeat Steps 8–9 for any additional remotes.
  11. Remove the key and test all remotes.

⚠️ Common Reasons Mazda 3 Programming Fails

  • Incorrect remote frequency or part number
  • Weak or flat remote battery
  • Timing steps not followed exactly
  • Door switch not registering
  • Immobiliser/transponder issue

If the remote works but the engine will not start, immobiliser programming is required.


Mazda 3 2014+ ⚠️ Diagnostic Programming Required

For 2014 and newer Mazda 3 models, remote and key programming is completed using OBD diagnostic equipment only.

🚫 Manual remote programming is not supported on newer models.


Need Help or It Didn’t Work? πŸš—

If your Mazda 3:

  • won’t enter programming mode
  • won’t start after remote programming
  • needs immobiliser or transponder programming

We can help.

πŸ‘‰ Mazda 3 key replacement & programming (Gold Coast)
https://needcarkeys.com.au/mazda-3-keys-gold-coast/

πŸ“ž Call or text Mike on 0494 149 841
πŸ“ Mobile service – no towing required